I'm just trying to get a HummingBoard-Edge (i.MX6 Quad, 2GB) working with Armbian_5.20_Cubox-i_Ubuntu_xenial_4.7.3. Unfortunately, the board is recognized as CuBox-i, U-Boot loads the wrong dtb file (imx6q-cubox-i.dtb) and I have no access to the internal eMMC card (mmcblk1). By the way, it's the same issue with ArchLinuxArm.
Do I have to somehow modify the U-Boot environment variables to get the board being recognized as Hummingoard2? Do you have any other ideas?
Thank you very much for your help!
Best regards
Andreas
U-Boot 2013.10-rc4 (Aug 31 2016 - 17:35:12)
CPU: Freescale i.MX6Q rev1.5 at 792 MHz Reset cause: WDOG Board: MX6-CuBox-i DRAM: 2 GiB MMC: FSL_SDHC: 0 In: serial Out: serial Err: serial Net: FEC [PRIME] Hit any key to stop autoboot: 0
Question
ahl
Dear all,
I'm just trying to get a HummingBoard-Edge (i.MX6 Quad, 2GB) working with Armbian_5.20_Cubox-i_Ubuntu_xenial_4.7.3. Unfortunately, the board is recognized as CuBox-i, U-Boot loads the wrong dtb file (imx6q-cubox-i.dtb) and I have no access to the internal eMMC card (mmcblk1). By the way, it's the same issue with ArchLinuxArm.
Do I have to somehow modify the U-Boot environment variables to get the board being recognized as Hummingoard2? Do you have any other ideas?
Thank you very much for your help!
Best regards
Andreas
Link to comment
Share on other sites
5 answers to this question
Recommended Posts