Jump to content


Photo

OrangePi Zero footprint files (schematic? .brd file?)


  • Please log in to reply
5 replies to this topic

#1 tech9

tech9

    Newbie

  • Senior Members
  • Pip
  • 3 posts

Posted 14 February 2017 - 12:56 AM

Hey,

 

I was wondering if anyone came across the board layout files.  If eagle cad files were available that would be great!  I'm assuming that they dont exist.. Or has someone designed a hat or shield for the OPi0?  I want to design one and was hoping someone else beat me to it.  If not i'll just have to measure it out and make it.  I dont want to reinvent the wheel so that would be cool 

 

Thanks



#2 renaudrenaud

renaudrenaud

    Member

  • Senior Members
  • PipPip
  • 15 posts

Posted 14 February 2017 - 02:21 AM

You can get a file from here :

https://forum.armbia...cad"#entry24955

 

In the file there is x100 error in dimensions, but it is a good base for the beginning.



#3 pzw

pzw

    Member

  • Senior Members
  • PipPip
  • 27 posts

Posted 14 February 2017 - 09:16 PM

I have made a footprint with just the 2x13 pin header.. Of course the library can be changed to add the 1x13 pin header.

The footprint has not been tested, and it comes with about 0.00% warranty! Use at your own risk! :)

 

Attached Files



#4 tech9

tech9

    Newbie

  • Senior Members
  • Pip
  • 3 posts

Posted 14 February 2017 - 09:54 PM

Thanks man.  I was going to do the same and just slap the standard 2x13 and try to guestimate the rest, but I really want the shield to go over the 2x13 and the 1x13 as well as those 3 pins next to the RJ45 jack.  I wish I had a printer, i could just test design, print, fix, repeat until i was confident they all lined up.  Thanks for the follow up.



#5 pzw

pzw

    Member

  • Senior Members
  • PipPip
  • 27 posts

Posted 14 February 2017 - 10:12 PM

The footprint is the whole PCB, but not with the 1x13 pin header. So you have the outline and the mounting holes...


  • tech9 likes this

#6 pzw

pzw

    Member

  • Senior Members
  • PipPip
  • 27 posts

Posted 16 February 2017 - 10:45 PM

I have updated the library (see post #3) to include a footprint with the 1x13 pin header, and an outline of a hat. The same still applies... Use at your own risk. Not tested!!