Hello Christos & Igor Pecovnik,
Thanks very much for all this great work!
I am very NOOB to building kernels
I wanted RT kernel to use with linuxcnc, specifically linuxcnc's 'hal' system
Before building, I repaired 2 patch files that are missing 0x0a at end of file
( they produce err saying the file ends in middle of line, actually meaning at EOF )
friendlyarm_m1_gigabit.patch ( ends in 0x3a)
ov5640-enhanced-device-with-vfe-drc-table-fix.patch (ends in 0x29)
I repair by simply opening in nano and immediately saving.
This action adds 1 0x0a byte to each file, and changes the timestamp.
But, changing the timestamp creates another problem,
the compile reports that it cannot update due to the change.
I chose to continue
Is this correct to add the missing 0x0a?
Can I ignore the errors about ending in middle of line?
I am trying to make preempt model 5,
Christos said "Did a fresh OrangePi Plus2E image, legacy, Debian jessie, desktop, RT, but the SD boot gives this"
Which preempt model did you succeed with?
regards
tomp