odluxon Posted January 24, 2017 Share Posted January 24, 2017 Screen goes black after starting kernel, i've installed the latest version of Armbian. Before that, there was no problem. I was using Armbian debian server Link to comment Share on other sites More sharing options...
Igor Posted January 24, 2017 Share Posted January 24, 2017 What kernel? What version? Based on those data I assume everything is ok. Wrote on mobile phone Link to comment Share on other sites More sharing options...
odluxon Posted January 24, 2017 Author Share Posted January 24, 2017 Everything is ok at starting, I see the "Armbian" logo in the middle of the screen, then logs come at the left corner of the screen. it goes black after "Starting kernel" log. It is latest Armbian. Original kernel.If it is neccesary, i can record a video. Link to comment Share on other sites More sharing options...
Igor Posted January 24, 2017 Share Posted January 24, 2017 Do you get a login prompt? If you do, nothing is wrong, just boot log is apparently directed to serial console. Link to comment Share on other sites More sharing options...
odluxon Posted January 24, 2017 Author Share Posted January 24, 2017 I can see that After that it goes off, just like in this photo cpu 1200 mhz allowed, 1200 mhz possible, 4 cores activedram 624 mhzhdmi/gpu activeusb ports activeeth0 10Mb/s/Half, Link: nowlan0 IEEE 802.11bgn ESSID:"*******" Nickname:"<WIFI@REALTEK>" Mode:Managed Frequency:2.432 GHz Access Point: ****** Bit Rate:150 Mb/s Sensitivity:0/0 Retry:off RTS thr:off Fragment thr:off Encryption key:****-****-****-****-****-****-****-**** Security mode:open Power Management:off Link Quality=89/100 Signal level=88/100 Noise level=0/100 Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 Tx excessive retries:0 Invalid misc:0 Missed beacon:0" Dmesg log: http://s3.dosya.tc/server10/b5alqt/log.zip.html Sorry about that, please click "INDIR" to download. Its turkish, if you want i can upload it somewhere else, or just put it here Link to comment Share on other sites More sharing options...
zador.blood.stained Posted January 24, 2017 Share Posted January 24, 2017 I see a relatively small square monitor, so you need to change the resolution manually using h3disp utility, assuming this monitor supports any provided resolution. Default setting for the kernel is 720p if I remember correctly Link to comment Share on other sites More sharing options...
odluxon Posted January 24, 2017 Author Share Posted January 24, 2017 It was working properly on previus build. And you are right, it is, and it should be supported. I'll try to use lower resolutions. Result:576i "input signal out of range" 720p50 not working 720p60 not working Higher resolutions cant be subject on this monitor. Link to comment Share on other sites More sharing options...
gnasch Posted January 25, 2017 Share Posted January 25, 2017 if your monitor is not of hdmi but of dvi type then you need to use the -d switch in h3disp utility. 1 Link to comment Share on other sites More sharing options...
odluxon Posted January 25, 2017 Author Share Posted January 25, 2017 if your monitor is not of hdmi but of dvi type then you need to use the -d switch in h3disp utility. Thank you, finally. I hadnt read description of h3disp. Link to comment Share on other sites More sharing options...
Recommended Posts