easyterm Posted May 18, 2017 Share Posted May 18, 2017 Hello! How exactly connect this device: ENC28J60 ethernet over SPI. Not understand about INT(IRQ) pin - is where number mapped this pin to plug in Zero and how configure FEX? Link to comment Share on other sites More sharing options...
nopnop2002 Posted May 18, 2017 Share Posted May 18, 2017 1 hour ago, easyterm said: Not understand about INT(IRQ) pin - is where number mapped this pin to plug in Zero and how configure FEX? In case of arduino, INT doesn't use it. http://www.homautomation.org/2014/10/27/how-to-choose-the-right-library-to-add-ethernet-enc28j60-to-your-arduino/ Link to comment Share on other sites More sharing options...
easyterm Posted May 18, 2017 Author Share Posted May 18, 2017 Yes, but performance is low. In Raspberry it is used for increase performance: https://www.raspberrypi.org/forums/viewtopic.php?t=18397 Link to comment Share on other sites More sharing options...
easyterm Posted May 19, 2017 Author Share Posted May 19, 2017 And where is place for attach to /dev/spidev1.0 ? Link to comment Share on other sites More sharing options...
easyterm Posted May 19, 2017 Author Share Posted May 19, 2017 After compile module on local Zero and copying to the directory and run depmod : sudo modprobe enc28j60 modprobe: ERROR: could not insert 'enc28j60': Exec format error and dmesg | grep enc28j60 | tail -n 1 [ 724.091705] enc28j60: no symbol version for module_layout Link to comment Share on other sites More sharing options...
Recommended Posts