tlmwt Posted August 12, 2017 Share Posted August 12, 2017 hi, i used armbian 5.14 (3.4.112)and the gc2035 worked nice. but in armbain 5.30 (3.4.113)the gc2035 shows the error : [CSI_ERR][GC2035]sensor_read err at sensor_detect! [CSI_ERR][GC2035]chip found is not an target chip. and in h3droid ,one of android img fo opi ,it was built in 3.4.113 too ,and it failed again... so what can i do to use gc2035 under .img built with 3.4.113? thanks. Link to comment Share on other sites More sharing options...
tlmwt Posted August 12, 2017 Author Share Posted August 12, 2017 solved 。 sunxi-pio -m "PG11<1><0><1><1>" to set PG11 enabled. now work on h3droid . it should be the same on armbian 5.30. 1 Link to comment Share on other sites More sharing options...
eggert Posted September 14, 2017 Share Posted September 14, 2017 perhaps a dump question, but I try the same... where did you put sunxi-pio -m "PG11<1><0><1><1>" on h3droid to get it working? Link to comment Share on other sites More sharing options...
martinayotte Posted September 14, 2017 Share Posted September 14, 2017 Probably, somewhere at startup, like in /etc/rc.local Link to comment Share on other sites More sharing options...
eggert Posted September 14, 2017 Share Posted September 14, 2017 He made it working under android... on linux I would know. But on h3droid I can't find init scripts, I'm no android expert I'm afraid. Link to comment Share on other sites More sharing options...
martinayotte Posted September 14, 2017 Share Posted September 14, 2017 1 minute ago, eggert said: I'm no android expert I'm afraid. Me neither ... Link to comment Share on other sites More sharing options...
Recommended Posts