Jump to content

OPI Zero 2 Plus UART1 & UART2


geocut

Recommended Posts

Hi,

 

I trying to use UART 1 & UART 2 at OPi Zero 2 Plus with no success with armbian stable and ubuntu server. I test all combinations, of fex settings, turn off everything 

except required uarts, set uart_type = 2 and etc, and it did not connect. UART0 and UART3 works fine, but I need cts-rts lines from uart2 for hi speed (it's uart_type = 4, but I would like to start regular uart first).

tested with picocom, ft232 & pl2303

I use 8 & 10 pins for uart 1 and 11&13 for uart2 as described at http://linux-sunxi.org/Orange_Pi_Zero  

Is it correct pins?

 

Thanks

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...

Important Information

Terms of Use - Privacy Policy - Guidelines