[Help wanted working on Structured Light 3d scanning software]

Hello All,

 

I was wondering if I could get some help with this project https://github.com/jhdewitt/sltk

 

This is a tool to do structured light 3d scans with a webcam and a projector. Currently the only way that I found to do this is with $1000+ commercial scanner.

 

John De Witt is just a single developer and I am just a tester with limited skills.

 

I currently have the tools compiling now on a s905x box with Armbian on it. I have compiled the tools but i am struggling with helping on the coding part and relaying information effectively and getting them to run properly on other hardware.

 

This tool would bring structured light 3d scanning down to an acceptable price point for a hobbyist. 

[Please Test img Octoprint on Orange Pi Lite]

On 7/13/2017 at 11:00 AM, ooaa said:

Hi

 

I have one issue some time when i start print my printer restart randomly

I had one do that as well until i changed my usb cable.  I used a shorter one and it resolved the issue

[Please Test img Octoprint on Orange Pi Lite]

Thank you so much for the feedback. This is for an article I am writing and will update and make it easier with full instructions. Also one for s905x box. 

 

Did you find wifi dropping periodically. I think I might have got a bad board.

 

On 26. 6. 2017 at 11:19 AM, pfeerick said:

@prahjister Have you set up Avahi on that image? Just wondering if something like http://octoprint.local would work with your image, making IP addresses not necessary? Otherwise it's probably either setting a fixed address on your router, using (sudo) nmtui to configure the connection (assuming network manager is managing the connection) or some ugly /etc/network/interfaces edits. 

 

I will setup avahi as well. Thank yoy

 

Also sorry for ling time between reply. I didn't have notifications setup properly

[Please Test img Octoprint on Orange Pi Lite]

Sorry guys thanks for the reply. 

 

No Cura Engine on this build. It is really old so didnt see the need

 

Camera does work. Dont recommend opi camera. Not very good. But to use usb camera.  First plug in the camera. Go into settings and video adjust the one ip address from 10.0.0.40 to the IP address of your orange PI. Then under power button turn on the webcam

 

Is anyone successfully using this for multiple days?

[Please Test img Octoprint on Orange Pi Lite]

Can someone please test this img on Orange Pi Lite. 4gb sd card or larger

 

You can use nmtui to connect to wifi

Connect to wifi the point browser to port 5000 of the IP address to see if gui starts and doesn't have any issues. http://x.x.x.x:5000

Thank you for your help.

 

login root password octoprint

 

Full instructions here

 

http://www.cnx-software.com/2017/07/11/how-to-use-octoprint-on-orange-pi-lite-board-amlogic-s905x-and-s912-tv-boxes/