Jump to content

Helios4: 3D printable bracket for 4 x 2.5" disks


skat

Recommended Posts

Tnx :-)

It took about 3 hours for the base, 1 hour for the top bracket. It depends on material and settings. I printed them with 0.35mm layer height and 20% infill. The black one is ABS, red one PLA. I guess PLA will do as well for the base, as there is enough cooling inside (PLA has a lower melting point and I wanted to make sure the screws dont fall out because of some heat)

 

Maybe its best to install PrusaSlicer https://www.prusa3d.com/prusaslicer/  and load the STL files and play with settings. Then slice and export gcode, and Slicer will tell all about material needed and how long it will take to print.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...

Important Information

Terms of Use - Privacy Policy - Guidelines