Jump to content

Use NanoPi Duo UART1 pins


hYtas

Recommended Posts

Hi there,

 

i need some help with using the UART1 pins 8 & 9. I own a Duo with Ubuntu 16.04.6

I've installed a software that is able to send codes over the UART1 pins to my smart home system. The software is 'active (running)' but has no connection via UART1.

 

UART1 is enabled(npi-config) but i does not work. WiringNP is required for my software and installed.

 

Is there any point i've missed? 

Did i have to switch UART1 pins to in- and output?

 

One error i get:


Service Control Manager on computer xx.x.x.xx cannot be opened. You may not have permission to do this.

 

PS: These pins must work, i rebuild another thing that's works fine! Software configs are the same, that is not the problem.

 

 

Edited by hYtas
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...

Important Information

Terms of Use - Privacy Policy - Guidelines