Jump to content

USB question


xwiggen

Recommended Posts

armbianmonitor -u

 

Either there are additional usb ports available via GPIO or some other components - whatever it may be - are connected internally via USB.

Link to comment
Share on other sites

7 hours ago, xwiggen said:

Can anyone enlighten me?

 

https://docs.armbian.com/Hardware_Allwinner-H3/

https://linux-sunxi.org/H3

 

Why all are enabled? Simply because there is nothing wrong if they are (on this particular board) and it would require either a test or seeing documentation to be able to know which to enable. Even this is almost nothing is one of those from the mountain of mini cosmetic tasks.

 

KISS and indolence prevails :P https://github.com/armbian/build/blob/master/config/boards/zeropi.conf#L5 (you are welcome to check on hardware which is actually needed and send a MR)

 

Link to comment
Share on other sites

19 hours ago, Igor said:

 

https://docs.armbian.com/Hardware_Allwinner-H3/

https://linux-sunxi.org/H3

 

Why all are enabled? Simply because there is nothing wrong if they are (on this particular board) and it would require either a test or seeing documentation to be able to know which to enable. Even this is almost nothing is one of those from the mountain of mini cosmetic tasks.

 

KISS and indolence prevails :P https://github.com/armbian/build/blob/master/config/boards/zeropi.conf#L5 (you are welcome to check on hardware which is actually needed and send a MR)

 

Yeah I understand indolence, I did a check on http://wiki.friendlyarm.com/wiki/images/7/71/ZeroPi_20190731_Schematic.pdf yesterday to find how everything is connected.

It's just my lack of insight on hardware level (gpio, low level boot sequence, how components connect etc) appears, never had to go deeper than simple minicom.

What's an MR?

 

Link to comment
Share on other sites

On 5/17/2020 at 7:13 PM, Igor said:

 

https://docs.armbian.com/Hardware_Allwinner-H3/

https://linux-sunxi.org/H3

 

Why all are enabled? Simply because there is nothing wrong if they are (on this particular board) and it would require either a test or seeing documentation to be able to know which to enable. Even this is almost nothing is one of those from the mountain of mini cosmetic tasks.

 

KISS and indolence prevails :P https://github.com/armbian/build/blob/master/config/boards/zeropi.conf#L5 (you are welcome to check on hardware which is actually needed and send a MR)

 

 

Just curious, I'm used to eth nics being handled by a single kmod, but there's something funky happening between sun8i-dmac and realtek?

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...

Important Information

Terms of Use - Privacy Policy - Guidelines