umiddelb Posted August 25, 2020 Share Posted August 25, 2020 Armbianmonitor: http://ix.io/2va5 Hi, the lastest kernel update issues the following lines in dmesg output: [ 12.214293] meson8b-dwmac ff3f0000.ethernet: Failed to reset the dma [ 12.215002] meson8b-dwmac ff3f0000.ethernet eth0: stmmac_hw_setup: DMA engine initialization failed [ 12.223988] meson8b-dwmac ff3f0000.ethernet eth0: stmmac_open: Hw setup failed Do I need to update the firmware as well? B.t.w. you may mention that armbianmonitor -u needs to be run as root, otherwise the fping check will fail. 0 Quote Link to comment Share on other sites More sharing options...
Igor Posted August 25, 2020 Share Posted August 25, 2020 44 minutes ago, umiddelb said: Do I need to update the firmware as well? It was confirmed fixed, then again reported not working properly ... We dealt with this insane a lot but we still don't know why this is happening. https://armbian.atlassian.net/browse/AR-376 Since we could not further delay with the release, the only thing we could do is to write "Mainline kernel can have troubles with network!!!" at the N2 download pages. 0 Quote Link to comment Share on other sites More sharing options...
umiddelb Posted August 26, 2020 Author Share Posted August 26, 2020 The problematic reset-gpios instruction is still present in the device tree description. Removing it solves the issue for my board (which is a pre-series test sample). The suggested patch doesn't apply since there are different pins involved (0x24 vs 0x21). 0 Quote Link to comment Share on other sites More sharing options...
umiddelb Posted August 28, 2020 Author Share Posted August 28, 2020 https://github.com/armbian/build/pull/2166 0 Quote Link to comment Share on other sites More sharing options...
gemini_geek Posted September 9, 2020 Share Posted September 9, 2020 hi, i am similar issue with odroic c2 eth0 cant connect to network on reboots, some time it does, most times it dont . i disabled ipv 6 also still no luck ? 0 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.