Josephjo Posted May 19, 2021 Share Posted May 19, 2021 Armbianmonitor: http://ix.io/3ni4 Before this I used to connect my APM 2.8.4 Flight controller to a Raspberry PI on Ground, Pin 8 and Pin 10. Today I tried to connect it to my orange pi zero plus2 H3. Pin 9, Pin 8 and Pin 10. On armbian-config toggle UART2. When i tried to connect to it using cat /dev/ttyS2 nothing came out. Once a while sent out some gibberish. I set the correct buadrate at 57600 and 91600 to no available. But I know the settings are correct because when I connect using USB through /dev/ttyACM0 it works. I tried ttyS1 and ttyS3 nothing came out of it. On Raspberry I had done this many times just by turning on the Serial Connection using raspi-config. Anyone have any solution for this? 0 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.