Booting into Cinnamon desktop after installation from armbian-config

[Esteve]

Good morning.

 

I have installed Armbian Bullseye (first file in this webpage: https://armbian.site-meganet.com/dl/rockpi-4b/archive/) on a Radxa ROCK Pi 4 SE.

After that I ran armbian-config and navigated to the Default section to install Cinnamon Desktop. Apparently the installation completes successfully and then coes back to the CLI. Now I am trying to start the desktop environment and I am unable to.

I have tried rebooting but it just goes to the CLI. Do I need to run a command like 'startx'? (startx is not working)

 

Thank you.

[Igor]

3 hours ago, Esteve said:

I have tried rebooting but it just goes to the CLI. Do I need to run a command like 'startx'? (startx is not working)

 

Check logs to understand why its not starting. Without CI, and interest that this is fixed from your side, we don't know that it breaks and why. I am trying to develop automated testings, but without help it will take years to complete.

 

Ready-made Cinnamon images should work.

[Myron]

@Esteve Have a look at this article: https://www.cyberciti.biz/faq/switch-boot-target-to-text-gui-in-systemd-linux/

What is the result of the command ...

systemctl get-default

... ?