sadegh Posted March 21, 2017 Share Posted March 21, 2017 Hi, By installing armbian jessie on my Orange pi plus 2 E, after login,I have a choice to change the resolution of screen( to 1920x1080),but unfortunately I have no succes. Can you please tel me how can I do that? Thanks Sadegh Link to comment Share on other sites More sharing options...
Igor Posted March 21, 2017 Share Posted March 21, 2017 - you have monitor via HDMI? - did you reboot? - what happened? Link to comment Share on other sites More sharing options...
sadegh Posted March 21, 2017 Author Share Posted March 21, 2017 -no.it is LG Flatron E22411S-BN -Yes -the same thing again. I can choose for No Change resolution,but I don't know how can I change it,when is installation is completed. Link to comment Share on other sites More sharing options...
Igor Posted March 21, 2017 Share Posted March 21, 2017 If resolution remain unchanged, there is a possibility that your system is corrupted / read only due to failed SD card. Link to comment Share on other sites More sharing options...
sadegh Posted March 21, 2017 Author Share Posted March 21, 2017 Ok. Thanks. I go try again. This time with an another SD card. Link to comment Share on other sites More sharing options...
jbird1 Posted March 22, 2017 Share Posted March 22, 2017 h3disp -m 1080p60 -d this works on OPi 2 Plus tried this as well in /boot/armbianEnv.txt verbosity=7 console=both machid=1029 bootm_boot_mode=sec disp_mem_reserves=on rootdev=UUID=138db2fa-ed4a-4003-8f07-0bce591c3ec5 rootfstype=ext4 #disp_mode=2160p30disp_mode "1920x1080p60" overlay_prefix=sun8i-h3 overlays=w1-gpio uart1 i2c0 spi-spidev param_w1_pin=PA20 param_w1_pin_int_pullup=1 param_uart1_rtscts=1 param_spidev_spi_bus=0 overlays=sun8i-h3-spi0-spidev Link to comment Share on other sites More sharing options...
sadegh Posted March 22, 2017 Author Share Posted March 22, 2017 Thanks jbird1! Link to comment Share on other sites More sharing options...
Recommended Posts