As the title says, my OpiPC don't want to boot. It starts to boot, with UART console I can see u-boot loading and doing its job, but just when it would start the kernel the console gets borked with non-ascii characters.
After this, the board just hangs there.
I've tested with 3 different images (written out by Etcher), checked the images checksum and checked the SDcard with F3.
This setup worked fine a month ago, when I last had the time to play with it.
Since than, the board was just lying on my desk, turned off.
Question
Drakoh
As the title says, my OpiPC don't want to boot. It starts to boot, with UART console I can see u-boot loading and doing its job, but just when it would start the kernel the console gets borked with non-ascii characters.
After this, the board just hangs there.
I've tested with 3 different images (written out by Etcher), checked the images checksum and checked the SDcard with F3.
This setup worked fine a month ago, when I last had the time to play with it.
Since than, the board was just lying on my desk, turned off.
Link to comment
Share on other sites
0 answers to this question
Recommended Posts