0
Sp0T

Orange PI A20 mini UART problem

Recommended Posts

Dear All,

 

I try to use the UART3 on my Orange Pi mini but it just won't work. I put a jumper on Pin 8 and pin 10 on the header. Also give read/write premmission to all users.

 

Based on this UART3 is /dev/ttyS2

[    0.000000] console [tty1] enabled
[    0.954713] sunxi-uart.0: ttyS0 at MMIO 0x1c28000 (irq = 33) is a U6_16550A
[    0.985810] sunxi-uart.2: ttyS1 at MMIO 0x1c28800 (irq = 35) is a U6_16550A
[    1.016890] sunxi-uart.3: ttyS2 at MMIO 0x1c28c00 (irq = 36) is a U6_16550A
[    1.047968] sunxi-uart.7: ttyS3 at MMIO 0x1c29c00 (irq = 52) is a U6_16550A
[    6.014770] systemd[1]: Expecting device dev-ttySAC2.device...
[    6.681738] systemd[1]: Starting system-serial\x2dgetty.slice.
[    6.690398] systemd[1]: Created slice system-serial\x2dgetty.slice.
[    6.695167] systemd[1]: Starting system-getty.slice.
[    6.702124] systemd[1]: Created slice system-getty.slice.

I Also checked the speed and other config settings:

root@orange:~# stty -F /dev/ttyS2
speed 115200 baud; line = 0;
kill = ^H; min = 100; time = 2;
-icrnl -imaxbel
-opost -onlcr
-isig -icanon -echo

When i try to send/receive some data i always failed, nothing happend.

console 1:
echo -ne '\033[2J' > /dev/ttyS2

console2:
cat -v < /dev/ttyS2

 

Can anyone tell me what did i wrong?

 

Thanks

Sp0T

Share this post


Link to post
Share on other sites

Dear All,

 

It was my bad. Forget to remove pins from gpio.

 

Regards,

Sp0T

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
0