Not getting any wireless
Greetings,
I've built a custom image for the BPI M4 Zero and have been using a wired USB cable for my config and development work, It's final destination will require wireless. So I started to configure that today and discovered that it does not find any wireless access points.
The device exists.
3: wlan0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_fast state DOWN group default qlen 1000
link/ether ac:6a:a3:3f:9c:65 brd ff:ff:ff:ff
I wanted to come around to this. Wireless works fine. The problem is the guy between the chair and the keyboard.
In the past I've been able to at least scan wifi networks without an antenna. I cannot on this board. I attached the antenna and I was able to see all the networks.
oof
-
Reputation Points