Jump to content

cubieboard2 can boot only from 4.xx kernel !?


OlegasK

Recommended Posts

Hello, i have cubieboard2. This board boots and runs  successfully with Armbian-5.xx-Cubieboard-Debian(Ubuntu)-xx-4.xx.xx image, but i have NO success to boot

and run any Armbian_5.xx_Cubieboard2_Ubuntu_xenial_default_3.4.xxx_desktop.img image. Except, that i was able to boot and run Armbian_5.38_Cubieboard2_Ubuntu_xenial_default_3.4.113 image once and it worked for few hours, i was able to install some SW.  After power up  in the morning cb2 boots until kernel starts, show some flickering colorfull screen  and in a second red power led is off and board is not showing any progress. HDMI display says no signal.

Maybe someone has the same problem ? So to make it short: any 4.xx.xxx kernel is loading and board is alive, any 3.4.xxx kernel hangs after Starting kernel.

 

regards

Oleg K.

P.S. added log file, will try to get some info

kernel log.zip

P.P.S.

found same problem in

 

Link to comment
Share on other sites

We recently dropped support for Cubieboard 2 since none of the crew has this board and no owner of those board didn't join as a board maintainer. On the theoretical base, it is extremely difficult to "see" if board boots :) 

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...

Important Information

Terms of Use - Privacy Policy - Guidelines