1GB EspressoBin won't Take 1GB U-Boot Firmware
I purchased a 1GB EspressoBin off of Amazon with the plan to run Armbian + OMV on it. Here's what it looked like upon initial boot with factory firmware. Which showed 1GB version.
TIM-1.0
WTMI-armada-17.10.1-b90dbf0
ENTER init_ddrgen
DDR_TOPOLOGY is 4 : DDR3, 1CS 1G
WTMI_CLOCK=2
Fill memory before self refresh...done
Now in Self-refresh Mode
Restore CAS Read and Write Latency
Restore termination values to original values
Exited self-refresh ...
DLL TUNING
==============
DLL 0xc0001050
Looks like the RAM chip is on the bottom. Here are top and bottom photos of the board.
Thank you for building those new images! It seemed to take just fine.
Marvell>> setenv ipaddr 192.168.1.201
Marvell>> setenv serverip 192.168.1.109
Marvell>> ping 192.168.1.109
Using neta@30000 device
host 192.168.1.109 is alive
Marvell>> bubt flash-image-1g-1cs-1000_800_boot_sd_and_usb.bin spi tftp
Burning U-BOOT image "flash-image-1g-1