Jump to content

Using the UART2 ports PcDuino 3 nano


edolnx

Recommended Posts

Greetings -
 

I'm trying to use the UART2 port (Connector J11 pins 1 and 2) and I'm not having much luck with Armbian 5.0 Vanilla. There are /dev/ttyS0-7 listed, but I get nothing from them (save ttyS0 which is the main console and in use by getty). I found several other articles in here talking about how to expose the GPIO pins, but I could not see how to set the "mode" of them. Any assistance would be appreciated!

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...

Important Information

Terms of Use - Privacy Policy - Guidelines