1 1
javalatte

OrangePi zero not working with 1-wire

Recommended Posts

4 minutes ago, mantouboji said:

I use the same hardware configuration for a long time , running very well under kernel 3.x 

still have the same problem?

Share this post


Link to post
Share on other sites
3 minutes ago, FRANK333 said:

still have the same problem?

 Yeah, It can't works at all.

 

[    0.000000]   Normal zone: 1152 pages used for memmap
[    0.000000]   Normal zone: 0 pages reserved
[    0.000000]   Normal zone: 131072 pages, LIFO batch:31
[    0.000000] Built 1 zonelists, mobility grouping on.  Total pages: 129920
[    2.876113] [TTM] Zone  kernel: Available graphics memory: 252532 kiB
[    6.055402] random: fast init done
[    6.761472] systemd[1]: Set hostname to <opione2>.
[    8.603638] gpio-20 (onewire@0): enforced open drain please flag it properly in DT/ACPI DSDT/board file
[    8.825062] thermal thermal_zone0: failed to read out thermal zone (-110)
[   10.501758] random: crng init done
[   57.867241] w1_master_driver w1_bus_master1: Attaching one wire slave 00.800000000000 crc 8c
[  116.503399] w1_master_driver w1_bus_master1: Attaching one wire slave 00.400000000000 crc 46
[  163.347210] w1_master_driver w1_bus_master1: Attaching one wire slave 00.c00000000000 crc ca

 

Share this post


Link to post
Share on other sites
22 minutes ago, mantouboji said:

I use the same hardware configuration for a long time , running very well under kernel 3.x 

I also had problems working, I reloaded armbian with the new kernel, connected sensor and resistance (checking that the circuit is correct) and works continuously for months.
Read my previous posts and connect everything as I did I must work! (from what you posted seems just the sensor that is mounted badly)

I'm sorry if I insist.:)

 

Share this post


Link to post
Share on other sites
11 minutes ago, mantouboji said:

Yeah, It can't works at all.

In /boot/armbianEnv.txt, along with adding w1-gpio to overlays, did you provided W1 parameters, param_w1_pin and param_w1_pin_int_pullup ?

Are you sure you have the proper pin ?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
1 1