[solved]Build-Armbian, 5.67 bionic 5.0 rc1 with S9xxx board won't boot even with correct dtb file


Recommended Posts

I just attempted several builds of Build-Armbian, 5.67 bionic 5.0 rc1 with S9xxx board. None of them will boot. It's almost like it's not reading the DTB right. It just sits at the MXQPro logo screen. I've edited to extlinux.conf and the uEnv.ini and even created a dtb.img but it doesn't seem to make a difference. I've used this same dtb with builds produced by balbes150 and it worked fine.  I'm a noob, but I'm not just trying to get this running. I plan to contribute to the project if possible. I was a software engineer in a past life. 

 

Any hints in the right direction would be much appreciated. For instance, is there a way to see the boot console so I can see i there is an error on boot attempt?

 

Thanks in Advance.

Jason Black

Link to post
Share on other sites

Donate and support the project!

  • Tido changed the title to [solved]Build-Armbian, 5.67 bionic 5.0 rc1 with S9xxx board won't boot even with correct dtb file
Guest
This topic is now closed to further replies.
 Share

0