0
Rahul

Baudrate supported by RK3399

Recommended Posts

Hi,

I am using rockpro64 "https://www.pine64.org/?product=rockpro64-4gb-single-board-computer" that uses Rockchip RK3399 Hexa-Core (dual ARM Cortex A72 and quad ARM Cortex A53) 64-Bit Processor.

 

My simple application is to have a UART communication.

When i run serial write with 1500000 Baudrate, then it works fine. But if i lower the baudrate such as 115200, then it throws garbage value. 

So can i get some suggestions here?

Thanks.

Share this post


Link to post
Share on other sites

The baudrate is 1500000. It's as simple as that.
A lower baudrate makes it so that you can't communicate with it, since it's not the right baudrate.

Share this post


Link to post
Share on other sites
2 hours ago, NicoD said:

It's as simple as that.

no.. :P

 

It could probably set to 115200 in DT. but then it had to be changed in u-boot as well.. and to keep stuff in a proper order.. for all RK3399 boards.. Is it worth to write a whole patchseries just for such a change.. I thought about it but I'm not sure..

Share this post


Link to post
Share on other sites

my UART script which does some funny monitoring in case the SBC doesn't respond anymore wouldn't need a $BAUDRATE variable anymore.... :lol:

The only gain IMO is that all other armbian supported SBCs run (to my knowledge) at 115200... But as said.. Don't think it's really worth it.. :P

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
0