Jump to content

armbian and udoo-quad: which one does fit most?


malaga

Recommended Posts

 

dear community

 

 

i own a udoo quad

 

which Armbian does fit to this hardware?

 

 

Quote


s://www.udoo.org/docs/Cookbook_Linux/Understanding_Linux_Software_Management_And_Installing.html

UDOO DUAL/QUAD retail line up consists of three models, sharing most of the features and different only for connectivity and i.MX6 processor used. All three models feature an embedded Arduino compatible section based on Arduino Due schematic. UDOO DUAL/QUAD’s dimensions are: 4.33 inch x 3.35 inch (11 cm x 8.5 cm).

    NXP® i.MX6Quad, 2\4 x ARM® Cortex™-A9 core @ 1GHz with ARMv7A instruction set
    GPU Vivante GC 2000 for 3D + Vivante GC 355 for 2D (vector graphics) + Vivante GC 320 for 2D
    Atmel SAM3X8E ARM Cortex-M3 CPU (same as Arduino Due)
    RAM DDR3 1GB
    76 fully available GPIO with Arduino compatible R3 1.0 pinout
    HDMI and LVDS + Touch
    2 Micro USB (1 OTG)
    2 USB 2.0 type A and 1 USB 2.0 internal pin header (requires adapter cable)
    Analog Audio and Mic jacks
    CSI Camera Connection
    on board Micro SD card reader (boot device)
    Power Supply (6-15V DC) and External Battery connector
    Gigabit Ethernet RJ45 (10/100/1000 MBit)
    WiFi Module
    SATA connector with power header
   

 

 

love to hear from you

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...

Important Information

Terms of Use - Privacy Policy - Guidelines