I hava a jetson nano and i use Armbian 20.05.4 Buster.
I installed a Fan with pwn, but it does not turn.
https://wiki.52pi.com/index.php/ICE_Tower_Cooling_Fan_For_Jetson_Nano_SKU:_EP-0113
A command /usr/bin/jetson_clocks should enable the pwm signal. (this is mentioned for nvidia image)
How can i enable the pwm signal in armbian?
Finally found time to test the fan.
May need to make a correction to the start line (add at the end of&). Without it, my fan wouldn't turn on.
Question. @Hollywood If you use the suggested value of 255, the fan turns on at maximum speed. I have tried different loads and even when using a value of 100 (and low fan speed), the temperature under load does not exceed 40 degrees (for temperature control, I run "armbianmonitor -m" in the terminal). And what temperature and under w