Jump to content

echo7394

Members
  • Posts

    6
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Just wanted to show off a bit of awesomeness! (Please excuse the dust)
  2. Edit: problem solved with armbian-add-overlay i2c-b.dts
  3. Lepotato with Armbian Jammy armbianmonitor -u is here: https://pastebin.com/UVbLxVH0 Trying to use I2c to drive a SSD1306 type oled screen. All wires have been tested for continuity and are good. Screen is connected as follows: Screen SDA -> Pin 27 Screen SCL -> Pin 28 Screen VCC -> Pin 4 Screen GND -> Pin 6 ive enabled i2c-a and i2c-b via armbian-config i2cdetect -y 0 0 1 2 3 4 5 6 7 8 9 a b c d e f 00: -- -- -- -- -- -- -- -- 10: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 20: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 30: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 40: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 50: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 60: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 70: -- -- -- -- -- -- -- -- i2cdetect -y 1 0 1 2 3 4 5 6 7 8 9 a b c d e f 00: -- -- -- -- -- -- -- -- 10: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 20: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 30: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 40: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 50: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 60: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 70: -- -- -- -- -- -- -- -- and finally lsmod | grep i2c shows nothing What am I doing wrong here?
  4. I just started fresh, all good again!
  5. Been using the Lepotato with Armbian fine for a few weeks. Typically accessing via ssh over the network, suddenly after a reboot, it's not appearing on my network, solid red light, solid green light, and a blue heartbeat as well as the NIC light blinking as if network connection is functioning normally, but my network is not assigning an IP address and the potato isnt sending any packets. What might the problem be here? HDMI shows no output, using Armbian Jammy made for the tato.
  6. Can OpenVFD be installed on the Armbian image for LePotato?
×
×
  • Create New...

Important Information

Terms of Use - Privacy Policy - Guidelines