Carlos Ervedoso

I'm currently running home assistant on my tvbox rk322x with USB boot and for wifi I'm using a usb adapter. for me it works with ledconf7 the light stays solid blue while it is booting and then it always blinks after being in the system. I couldn't get the internal WiFi to work and I'm not going to waste much time on it either. For my application this is fine. I want this just as home assistant learning

Também inicialmente não segui bem o manual, depois instalei o Ubuntu em dualboot com Windows e consegui apagar o flash com sucesso. Aí conectei o TVbox a cabo no modem e consegui acessar o TVbox usando o PuTTY. Configurei o ledconf7 e agora tenho led e hdmi. Eu poderia inicializar com multitool e libreelec, mas com Armbian não consegui até apagar completamente o flash. Agora gostaria de conseguir fazer o wifi interno funcionar, mas não consigo identificar o chip

sorry my bad english but translator dont translate correctly

Bom dia, não compilei, apenas usei uma versão pronta. o segredo era apagar todo o emmc . Não mostrará nada no HDMI. Eu dimensiono tudo com massa. mas deve estar conectado à internet via cabo. depois de iniciar e usar rk322x-config para alterar as configurações. Escolhi rk3228a, ram ddr3 e ledconf 7. depois disso acende a luz azul e já tenho hdmi a imagem que usei foi esta: Armbian_23.11.1_Rk322x-box_bookworm_current_6.1.63_minimal.img mas inicialize com qualquer imagem

yes the hdmi works. I even have klipperscreen installed. apparently everything works except the wifi. the wifi I'll try to get the chip model and see if I can get a driver for it or try with an external receiver. Sorry but my English is not very good

Good evening, I want to thank you for your help, I finally managed to boot and I already have the box with klipper and mainsail. After dual booting the computer to be able to have Ubuntu. I was able to use rkdeveloptool to completely erase the TVbox's flash and now it starts from SD. Overlays=led-conf7 only Change led. I make more tests

Good evening, I have an H20 box. I've broken it several times and recovered it. I have the backup made with multitool. I can start multitool and, for example, libreelec from SD. but I noticed that when creating the card with whatever the Armbian image is, it never starts and only creates a partition, unlike multitool and libreelec. that I'm doing wrong. Below are photos of the box