[Screen goes black after starting kernel]

if your monitor is not of hdmi but of dvi type

then you need to use the -d switch in h3disp utility.

Thank you, finally. I hadnt read description of h3disp.

 

[Screen goes black after starting kernel]

It was working properly on previus build. And you are right, it is, and it should be supported. I'll try to use lower resolutions.

Result:
576i "input signal out of range"

720p50 not working

720p60 not working

Higher resolutions cant be subject on this monitor.

[Screen goes black after starting kernel]

I can see that

 

After that it goes off, just like in this photo

 

 

cpu       1200 mhz allowed, 1200 mhz possible, 4 cores active

dram      624 mhz

hdmi/gpu  active

usb ports active

eth0      10Mb/s/Half, Link: no

wlan0     IEEE 802.11bgn  ESSID:"*******"  Nickname:"<WIFI@REALTEK>"
          Mode:Managed  Frequency:2.432 GHz  Access Point: ******
          Bit Rate:150 Mb/s   Sensitivity:0/0
          Retry:off   RTS thr:off   Fragment thr:off
          Encryption key:****-****-****-****-****-****-****-****   Security mode:open
          Power Management:off
          Link Quality=89/100  Signal level=88/100  Noise level=0/100
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0"

 

Dmesg log: http://s3.dosya.tc/server10/b5alqt/log.zip.html

Sorry about that, please click "INDIR" to download. Its turkish, if you want i can upload it somewhere else, or just put it here

[I can't set Orange Pi plus 2 clock speed]

Thanks for explanation

[I can't set Orange Pi plus 2 clock speed]

I remember that i had better performance after i set its speed to 1.54 ghz, but the expert is you.

[Screen goes black after starting kernel]

Everything is ok at starting, I see the "Armbian" logo in the middle of the screen, then logs come at the left corner of the screen. it goes black after "Starting kernel" log. It is latest Armbian. Original kernel.

If it is neccesary, i can record a video.

[I can't set Orange Pi plus 2 clock speed]

I can't set Orange Pi Plus 2 clock speed to 1.54Ghz.
Please fix it

[Screen goes black after starting kernel]

Screen goes black after starting kernel, i've installed the latest version of Armbian. Before that, there was no problem. I was using Armbian debian server

[update version]

Yea, im looking for it too. I have a lot of things installed on my opi2+ now, it seems i have to reconfigure whole thing again

But it worth! now i can install php7 mysql5.7 etc.