Dantes Posted October 26, 2023 Share Posted October 26, 2023 (edited) My audio volume was very very low, and very annoyingly I had to boost to 200% 300% which had the problem that the volume buttons were not working properly. You just cant see anything above 100% unless you go into the control panel. Now when it comes to audio I'm the village idiot, but I found a proper solution I think. After some experimentation I found that the module "module-cli-protocol-unix" ( #20 in my case) can be amplified with pactl set-sink-input-volume 20 10db Now YMMV depending on your attached hardware, so change the 10db to whatever suits your situation. After that I made it permanent by adding it to the /etc/pulse/default.pa like this: # Default volume amplification set-sink-input-volume 20 10db Yay! Edited October 26, 2023 by Dantes 0 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.