mbrennfleck

UARTS: I followed the instructions from tkaiser. Success Thank you. About the IR reveiver: I found that the module sunxi_cir provides me a working /dev/lirc0 device. Did not see that before. One more question: where do i find documentation about the mapping of the pins described in script.fex (like PAXX, PCXX, PGXX) to the actual physical mapping on my Orange PI PC board? Thanks, I like that forum

Hi, am new on orangePI, Hope my question is not to dumb. I am using the Armbian_5.05_Orangepih3_Debian_jessie_3.4.110.raw image. Kernel is Linux orangepipc 3.4.110-sun8i #18 SMP PREEMPT Tue Mar 8 20:03:32 CET 2016 armv7l GNU/Linux I want to access a serial device connectet to the pins 8 and 10 on the GPIO connector, described at uart 3. /dev/ttyS0 is the 3 connector pin close to the power plug. there is no /dev/ttySn with n>0 and the /dev/ttyGSn are also not the ones to use. How can I create the right device? Same about the IR receiver, Is there any device that represents the IR receiver? Are there modules to load? thanks a lot for help