costel.vasiliu

Hello, Indeed, it works for kernel 4.6.x, but doesn't work for default kernel (3.4.112), of course, applying the appropriate patches for u-boot and kernel; mmcblk1 cannot be seen. And, MALI Open GLES works only on legacy kernel ... ... still searching ....

Hello, Me, again !! I used pwm on Lime2 with 3.4.109 and works fine (generating sounds with 2-3 Khz) But, with 3.4.112, I have sound up to 363 Hz. Beginning with 364 Hz ... no sound !! I verified with an oscilloscope and I don't have rectangular waves over 364 Hz . Did anybody experienced such a strange thing ? What can be this 364 limit ? Thanks, Regards,

Hello, I tried several times to install debian in eMMC on Lime2, using nand-sata-install, without success, getting with the message : "There are no targets. Please check your drives." Note that on the same board, the official debian image provided by Olimex is working and can be installed in eMMC Checking with "dmesg | grep mmc", I don't find mmcblk1 (only mmcblk0). I tried with 3.4.112 image from armbian (also with 4.5.2). I installed a lot of images on Lime2 in NAND, so I'm not so unexperienced, but I don't understand where I'm wrong (or what I don't know) Thanks for any help ! Regards,

Hi ! I found something related to this error message : https://github.com/cubieplayer/Cubian/issues/427 Is a little bit old and it is for another platform, but this comment : "solstag commented on Feb 12, 2015" may help. Of course, I reinstalled 3.4.106 and it works fine. I suspected the unit, but the same error appeared on other 3 units tested, bought at different times (I have a lot of Lime2 4G in production and all of them are working fine with 3.4.106) I need 3.4.112 for native overlayfs (in 3.6.106 I patched with AUFS) and for MALI driver. Otherwise, 3.4.106 should be enough for my purpose. Another remark : the error appears randomly. Yesterday, I compiled the whole image (jessie desktop) from scratch (according to Igor's instructions). Until now, after 12 hours, I have no problem, so, still testing ... Thanks, Greetings !

Hi ! Ref : Olinuxino LIME2 4G with new 3.4.112 kernel When installing to NAND, on the console I see a lot of : PHY_PageRead : too much ecc err,bank 0 block 276,page 4 PHY_PageRead : too much ecc err,bank 0 block 276,page 18 and so on ... Sometimes the installation succeeded, sometimes not, but the system is often instable, and finally, fully unusable. I tried all the precompiled images, then I compiled myself, but the same problem ... Until now, I used 3.4.106 without problems Thanks for support ! Greetings ,