I'm on a Rockpro64 rev2.1 and wanted to use the maximum of the availiable Power of this SoC, so i tried using cpufrequtils and the amrbian config for doing so and noticed two things:
I can only set one of my CPU's frequencies and the maximum is 1800 MHz, so i searched this forum for a while and found out how to show the device tree table which is currently loaded(dtc -I fs /sys/firmware/devicetree/base/)
and there is one unused mode for both of my CPUs, a 1992 MHz mode for the big chip and a 1512 MHz mode for the small chip, and at this point im stuck.
What could i do to load this modes in the cpufrequtils or the armbian config?