Hi everyone,
I'm trying to get armbian running on an A20 based board. Been through the wikis (armbian and sunxi-linux) but I get a problem that is hard to figure out (for me).
The board is an old tablet, know as Inet K100 (mine is branded Storex), and I'm trying to get the legacy kernel running on it to get a desktop install with LCD etc...
Using sunxi-tools, I was able to get a fex file from the board.
With the armbian git cloned into an Ubuntu Bionic VM, I added a board conf file in config/boards/storexk100.conf and moved the fex file in config/fex/storexk100.fex
I'm also using this temporary userpatch to get the compilation going, but I'll need to go through it to get the right values inside the defconfig and dts files.
During configuration, I use the default kernel parameters, I get an image, burned it to an sd card, and I was able to boot up until a point where I get this error. Side note, backlight flashes during boot, so either the fex or the defconfig file are loaded.
So my obvious question is : why ?
u-boot seems to be loading fine and then trying to load the kernel, so I guess u-boot is working fine, but the problems seems to come from the kernel.
Is there anything special to do with the kernel configuration for an A20 based board, like disabling some stuff ?
Or is it more likely due to a bad defconfig or dts file ?
I thought that the dts file was not needed for the legacy kernel, so do I really need it ?
Thanks for taking the time to answer my questions
Full boot log below.