Jump to content

MarekBelisko

Members
  • Posts

    10
  • Joined

  • Last visited

Everything posted by MarekBelisko

  1. Hi, I'm trying to build debian kernel but using mainline 5.4.12 + patches from patch/kernel/sunxi-current. I took non disabled patches and apply patch -p1 for all of them and it fails at patch 0010-general-h6-add-dma-i2c-ir-spi-uart.patch in first hunk because opp node in dts doesn't exists. It's not in mainline not in patches. I have no idea how this works though. Is this patch then skipped or? Thanks. Marek
  2. Hi, I booted today latest Buster on NanoPi Neo2 plus and I cannot see bluetooth interface working. There is no mention of bluetooth in dmesg. Is this feature even available? Thanks. BR, marek
  3. Needed to update dtb to my board. Sorry for noise.
  4. HI, I have flashed Armbian_19.11.3_Aml-g12_bionic_legacy_5.3.0_20191126.img to sdcard and then start application update&backup and when confirm Update I got this: https://pastebin.com/a1Mexx61 Looks like board cannot boot. Any ideas? Thanks. BR, marek
  5. OK so on x96-mini should work stock u-boot and I don't need old android one then? Just out of curiosity is there any chance to recover if 2019.10 will hang? Also is there any reason why mainline is not used in current amlogic armbian releases? Thanks.
  6. OK so it still use android u-boot. Is there some u-boot which work on this platform (I need to patch it). Thanks.
  7. If you see test points close to RX, TX there are 2 pads which needs to be shortcut (with 0ohm resistor) to have RX, TX signals on test points.
  8. Resolved, I need to solder 0ohm resistors on pad to have UART working -> maybe it will help someone in future also
  9. Just want to ask I want flash armbian to emmc still old steps are valid? Just for my understanding image flashed to eMMC will use mainline u-boot and armbian kernel to boot? or still android ones are used? Thanks.
  10. Hi, I bought x96mini with 2G RAM and 16G emmc and booting to android works fine. I want to run armbian on it so I followed this post: https://blog.danman.eu/bricking-and-unbricking-vontar-x96-mini/ to solder serial console. Aftre plugging to pc and starting minicom I cannot see any info out of serial console. Does anybody experience similar or something else must be done to have output on serial console? Thanks a lot. Marek
×
×
  • Create New...

Important Information

Terms of Use - Privacy Policy - Guidelines