sunshinetime

  • Content Count

    2
  • Joined

  • Last visited

  1. Hi Igor, Thanks for your suggestions. I've tried to update the kernel as suggested in the page you linked to but I get an error: "Test install failed. Can't change firmware" The contents of /tmp/switch_kernel.log are this: linux-image-current-sunxi=19.11.3 linux-dtb-current-sunxi=19.11.3 linux-u-boot-olinuxino-a20-current Any suggestions on how to continue from there?
  2. hi all, I've been running into an issue where the kernel starts throwing error messages (https://pastebin.com/bmPJPeq0), the board becomes very slow and the cpu load goes to 11 and stays there. This seems to happen when I change the CPU freq using armbian-config to anything lower than 528MHz. Any ideas how I could resolve this?