Jump to content

feelcold

Members
  • Posts

    3
  • Joined

  • Last visited

  1. Yes, that helps! Now Ethernet working fine and well. Thank you so much for the tip!
  2. I will try to replace allow-hotplug with auto eth0 and advise you about the results. my dmesg output
  3. Hi! I'm new to Armbian and I have a problem with Internal Ethernet device on my Orange Pi One. Ethernet link successfully up on boot, but after 2-3 hours it goes down and only restarting it with /et/init.d/networking restart helps for the next 2-3 hours. But after 2-3 hours it goes down again and did not up untill I'll do restart networking manually again. I use the lastest Armbian_5.14_Orangepione_Debian_jessie_3.4.112. This is a log messages, which I found when network fails: Jul 27 16:00:01 localhost rsyslogd-2007: action 'action 17' suspended, next retry is Wed Jul 27 16:01:31 2016 [try http://www.rsyslog.com/e/2007 ] Jul 27 16:00:05 localhost kernel: [ 6087.706379] gmac0: probed Jul 27 16:00:05 localhost kernel: [ 6087.706753] gmac0 gmac0: eth0: eth0: PHY ID 00441400 at 0 IRQ poll (gmac0-0:00) Jul 27 16:00:05 localhost kernel: [ 6087.720745] ADDRCONF(NETDEV_UP): eth0: link is not ready Jul 27 16:00:09 localhost kernel: [ 6091.700310] PHY: gmac0-0:00 - Link is Up - 100/Full Jul 27 16:00:09 localhost kernel: [ 6091.700639] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready Jul 27 16:05:01 localhost rsyslogd-2007: action 'action 17' suspended, next retry is Wed Jul 27 16:06:31 2016 [try http://www.rsyslog.com/e/2007 ] Jul 27 16:15:01 localhost rsyslogd-2007: action 'action 17' suspended, next retry is Wed Jul 27 16:16:31 2016 [try http://www.rsyslog.com/e/2007 ] Jul 27 16:17:01 localhost rsyslogd-2007: action 'action 17' suspended, next retry is Wed Jul 27 16:18:31 2016 [try http://www.rsyslog.com/e/2007 ] Jul 27 16:25:01 localhost rsyslogd-2007: action 'action 17' suspended, next retry is Wed Jul 27 16:26:31 2016 [try http://www.rsyslog.com/e/2007 ] /etc/networking/interfaces # Wired adapter #1 allow-hotplug eth0 iface eth0 inet dhcp # Local loopback auto lo iface lo inet loopback root@orangepione:~# ifconfig eth0 Link encap:Ethernet HWaddr 06:3b:3f:96:d0:88 inet addr:10.30.30.109 Bcast:10.30.30.255 Mask:255.255.255.0 inet6 addr: 2a00:1370:8132:db5:43b:3fff:fe96:d088/64 Scope:Global inet6 addr: fd0e:8f4a:1bf7:1:43b:3fff:fe96:d088/64 Scope:Global inet6 addr: fe80::43b:3fff:fe96:d088/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:12303 errors:0 dropped:0 overruns:0 frame:0 TX packets:2365 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:944950 (922.8 KiB) TX bytes:999070 (975.6 KiB) Interrupt:114 lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 inet6 addr: ::1/128 Scope:Host UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:8 errors:0 dropped:0 overruns:0 frame:0 TX packets:8 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:1104 (1.0 KiB) TX bytes:1104 (1.0 KiB) P.S. I was try the Raspbian_For_OrangePi_PC_v0_8_0 image file on my Orange Pi One board and Ethernet running good and stable on it. So, I think that this is not the power supply or cable link problems.
×
×
  • Create New...

Important Information

Terms of Use - Privacy Policy - Guidelines