Daniel Cagarrinho

I boot using a USB stick, then I used the two commands : ``` sudo mv /lib/firmware/brcm/brcmfmac4330-sdio.txt /lib/firmware/brcm/brcmfmac4330-sdio.txt.old sudo ln -s /lib/firmware/brcm/brcmfmac-ap6330-sdio.txt /lib/firmware/brcm/brcmfmac4330-sdio.txt ``` after that I entered in the armbian-config and managed to connect to a wifi network, then restarted the box and no longer be able to boot armbian! Conclusion this two commands turn possible the usage of wifi, but somehow causes a problem removing the ability to boot the system after the change!!! Ps: I just can post 1 time a day here!

I have successfully connected wifi, but wen I reboot the box the os cannot start properly!!! I have followed the instructions from this topic

I need some help, did anyone get wifi working with tanix tx3?? what i can do to make it work???

Hello Alexx, did you get wifi working with meson-sm1-sei610-ethfix.dtb?? Or it is necessary to do something else? Once again tank you very much for your help, since you have helping me i have home assistant running perfectly :)

Anyone can put the vfd working normally?? Mine was stuck with the message “boot” it is possible to put the clock back working??

Solved :-)

Thanks a lot for the help! the only problem I had was that it doesn't boot from the SD card, only via usb. now everything is working with home assistant. the only problem i have now is that i can only access the home assistant by ip and i can't through the url http://homeassistant.local:8123 or any internal url

Hello everyone, I bought a tanix tx3 s905x3, and I would like to install armbian to use the home assistant, but I don't know how ... Is it possible for someone to help me step by step? I never did anything like that ... thanks in advance