enigmasphinx

@jock had to wait for 24 hrs to reply to your post. I will try the other images when I have the time and play around with it. Here are the pics: https://drive.google.com/file/d/1JGB3Ihnp1kKlnuh6fkCftuHMoj0aInjD/view?usp=drivesdk https://drive.google.com/file/d/1JImmtinhNfkJxE8qCE_0q9afLQHg3sRL/view?usp=drivesdk

Thanks jock for this post. I was able to unbrick my device. I now have successfully installed Armbian on my device and loves its performance by following this post. My device is called Ninkbox N1 Max RK3318. I was trying to look for a firmware suitable for my device but I am unable to find the exact one. I tried asking support from their main website but to no avail. So I tried installing different firmware on my device with almost the same chips until I ended up bricking the device. Unfortunately I already bricked the device before landing into this post so I was not able to backup my original firmware. For some unfortunate twist of fate I also have those BGA chips with no exposed pins. Upon further examination there are two round copper at the back of the board where the BGA chip sits. After burning the image on an SD card I tried shorting the round coppers with a piece of staple wire and it gave me the Multiboot window. I am writing this for those other people who may have the same device as mine and is looking to setup Armbian or probably trying to unbrick their device. This is my EMMC Chip https://drive.google.com/file/d/1J5E8OGBUOV_sdQ0VF0glIt4t6yhRKxrr/view?usp=sharing The picture of my device https://drive.google.com/file/d/1J2Ha8nUhA5hhXne_vqHdyzLBOlxCWcMV/view?usp=sharing The round copper at the back of the board to short https://drive.google.com/file/d/1J-X_9Y4jKr8u87lEosGkBmtpwjdxGsFb/view?usp=sharing My device desktop after successful install https://drive.google.com/file/d/1J5hkfP7A4U5r6xO7P9Zgv8ArpjUmZJ0g/view?usp=sharing