I apologize for the long post but have no idea on how to proceed:
I loaded version Armbian_21.02.1_Nanopi-r2s_focal_current_5.10.12_minimal.img.xz, to check if older kernel would work.
- After flashing the sdcard, boot works well, it asks for root password, new user and localization information.
- When I run "reboot", the reboot freezes most of the times at:
Sometimes, if I remove the network cable and then reconnect it while the device is powered down, then start it, it then freezes on the ttyS2 line, sometimes freezes a few lines after (Finished Armbian ZRAM config).
- When I removed the network cable and started the device, then boot worked fine:
- Plugging the network cable, device still works (not sure how long it will take to freeze), interface gets IP.
- Rebooting again the device (now with network cable plugged in), boot works fine.
- I kept rebooting the device for 3 or 4 times with network cable plugged in, and then it froze again:
- removing and plugin in again power, it boots fine. But I believe it is somewhat random. The only configuration I did not experience the system hanging is without network.
- Analyzed boot sequence when device works and when it does not work and the boot sequence is absolutely the same, no additional error messages.
- Error messages shown on boot (attached file has for full log):
Any idea of what can I do next? The only reproducible steps are the first 4 steps I listed. After that it can or cannot work (when network cable is plugged).
r2s_boot.txt