Sylva1n

Curious response from Xunlong:

Hello, after a poweroff command, the board Led switches off but the ethernet port Led still green blinks. The os has well performed the shutdown (I can see this through the UART). How is it possible? Thanks

Definitely sure: the PCB form factor isn't the same. One can't confuse OP3 and OP3LTS.

Hello, on a fresh install (Armbian_22.08.1_Orangepi3_jammy_current_5.15.63), the ethernet eth0 interface doesn't retrieve any IP. Here comes the kernel ethernet related messages: After that, I have launched a dhclient command that took several minutes to stop. Then, an APIPA address is attributed to eth0 nterface. So I have launched armbian-config to set the eth0 to static. And it worked. But how to make DHCP works? Thank you PS all others devices on my network can retrieve an IP by DHCP. I also tried others OS on my Orange Pi 3 boards and they grab an IP. The issue comes from Armbian.

Hello, I own several Orange Pi 3 which I bought at different times. The last batch couldn't run the firmware I used previously: the ethernet was broken. So I suspect there is a new ethernet chipset on it. Current Armbian (Armbian_22.08.1_Orangepi3_jammy_current_5.15.63) works on both types. How could I differentiate the chipsets from the command line? Thank you