Sharelter

Hi, I solved this problem by editing the `boot.cmd` file under /boot I checked `/boot/armbianEnv.txt` and got nothing wrong, but the `boot.cmd` still uses the old `mmcblk0p1` which is not correct. After I edited it and compiled it to boot.scr, and the system finally boots up normally again!

Hi, I just downloaded the newest release of Armbian and flashed into the SD card, it boots up fine from the SD Card. But I wanna install the system into the Samsung PM9A1 SSD, So I followed the instruction on the armbian page, partioned the drive and made a ext4 filesystem. but I got stuck when I tried to boot up from SSD. I hooked up a serial cable and got this information Any idea about this?

I installed the latest Armbian image and used a 1080P portable monitor to finish the install process. But when I use my bigger monitor with 2560x1440 resolution, it cannot output signal via HDMI. I searched about it, but most of them are about windows/x86 contents. Any idea about that?