Tomek51

I think my box is broken. Everything worked before and then I wanted to install some other Linux and it didn't work. Now I wanted to install Android again but multitool sd won't start, the LED only lights up red. factorytool recognizes maskrom but when I want to install firmware the error message "Download boot fail" appears. Can the box still be repaired?

@gerotmfThank you a change actually really helped.

I have the problem that the USB connection randomly goes out. As a result, my 3D printer no longer works. Sometimes the printer runs over 15 hours and the USB connection works and sometimes the USB connection stops after 8 hours. What could this be?

@argen96 I've now got it working and everything is working very well. The only problem is that the box just crashes in the middle of printing. Sometimes it prints for more than 15 hours without problems and sometimes it crashes after 8 hours. That means the printer just stops and nothing happens anymore. The tv box can no longer be reached via the Internet either. Can I see a log somewhere of what exactly is happening?I took this image, is that the right one? Armbian_23.02.2_Rk3318-box_bullseye_current_5.15.93.img.xz Does the system perhaps have a standby mode and that is where the problem is?

Many thanks for the answer. Then I order a H96 Max with rk3318 and 4gb RAM. That should be enough for my needs

This is a very good question. I also have to decide whether I want a box with rk3318 or one with s905x2-s905x3.. What is better supported here and where is armbian more stable on? Maybe an expert can say something about that 😁

Hello I would like to use Klipper for a 3D printer and need a cheap Linux system for this. Which chip should I take the RK3318 or RK3328? Or is there a better cheaper alternative?