My Sata SSD drive works very slowly on Orange PI 4, using usb 3.0 port. On PC based on Windows 11 via usb 3.0 it works correctly.
I found problem on Armbian 23.02(trunk, 30.12.2022, edited parameters: installed software, bluetooth parameters) when I try move system onto SSD, first time it works normaly, but not so fast, as expected and automatically starts in read only mode. Read only mode I have fixed. Sometimes it breakes ext4 partition, that I've fixed using fsck, and fix again when ext4 breakes again and not working/works badly. After some time it begun freezing. I tried to find solution by myself, but not found good advices. I've tried some mounting parameters, that gave no result at all. I've tried advice about uas driver - used parameter "usbstoragequirks" in /boot/armbianEnv.txt, that makes work SSD a bit faster, but not solving my problem. I think maybe I need to reinstall system with a new image, Armbian 23.05(19.03.2023 trunk, edited params: disabled preinstalling software, bluetooth). it starts work very badly - freezes, disconnects, writes slowly. Also not working trim via options in mount params or via fstrim (disk has trim). Also SMART not working when usbstoragequirks parameter not set.
On 23.05, clean system, also without fix usbstoragequirks
i.e. it started test and stoped with error.
On 23.02+usbstoragequirks
i.e. stopped with error too
and dmesg after test on 23.02
maybe be useful info that my audio output 3.5 mm stopped playing on right channel of speakers, left works correctly, stereo device it detects as mono(info from alsamixer). tested speakers and cable - all fine. tested headphones via 3.5 mm - same problem, only left channel.
also maybe useful SMART from opi4 via smartctl:
sorry for my bad english, I'm learning it
thanks in advance
