Hi there,
I'm using the latest version of armbian to run the linuxptp for the ieee1588v2 clock. When I check the timestamp status, the 1Gbps port which is the RTL8122 is no problem, but the 2.5G ports RTL8125BG are only supporting the software timestamp.
However, when I checked the Realtek website, it says that the 8125BG also supports the IEEE1588 clock. I tried to install the driver, but it did not work.
As a beginner in Linux, I probably don't have the knowledge to compile drivers, in this case I sincerely hope that armbian could officially support the hw ptp timestamp in 8125 NIC.
Thank you very much!
nanopi-r6s:~:# ethtool -T end0
Time stamping parameters for end0:
Capabilities:
software-transmit
software-receive
software-system-clock
PTP Hardware Clock: none
Hardware Transmit Timestamp Modes: none
Hardware Receive Filter Modes: none
nanopi-r6s:~:# ethtool -T end1
Time stamping parameters for end1:
Capabilities:
hardware-transmit
software-transmit
hardware-receive
software-receive
software-system-clock
hardware-raw-clock
PTP Hardware Clock: 0
Hardware Transmit Timestamp Modes:
off
on
Hardware Receive Filter Modes:
none
all
ptpv1-l4-event
ptpv1-l4-sync
ptpv1-l4-delay-req
ptpv2-l4-event
ptpv2-l4-sync
ptpv2-l4-delay-req
ptpv2-event
ptpv2-sync
ptpv2-delay-req
