MaSchuessler

Yes! that works!!!!!! Thank you very much! I just changed dtb files in boot.cmd and compiled it!

Ok I did som testing, it works fine on udoo quad, udoo dual lite does not start do I have to modify the device tree?

Hi Igor, I just set up my virtual machine completely new. I am getting following (unchanged) result: U-Boot SPL 2015.10-armbian (Sep 05 2016 - 18:35:42) U-Boot 2015.10-armbian (Sep 05 2016 - 18:35:42 +0200) CPU: Freescale i.MX6DL rev1.1 at 792 MHz Reset cause: POR Board: UDOO DualLite DRAM: 1 GiB MMC: FSL_SDHC: 0 *** Warning - bad CRC, using default environment No panel detected: default to HDMI Display: HDMI (1280x720) In: serial Out: serial Err: serial Net: Phy 4 not found using phy at 4 PHY reset timed out FEC [PRIME] Error: FEC address not set. Hit any key to stop autoboot: 0 switch to partitions #0, OK mmc0 is current device Scanning mmc Found U-Boot script /boot.scr ** File not found /boot.scr ** ** Unrecognized filesystem type ** Found U-Boot script /boot/boot.scr 824 bytes read in 88 ms (8.8 KiB/s) Running bootscript from mmc ... ## Executing script at 12000000 0 bytes read in 59 ms (0 Bytes/s) 0 bytes read in 64 ms (0 Bytes/s) 37690 bytes read in 379 ms (96.7 KiB/s) 6137616 bytes read in 419 ms (14 MiB/s) Kernel image @ 0x12000000 [ 0x000000 - 0x5da710 ] ## Flattened Device Tree blob at 18000000 Booting using the fdt blob at 0x18000000 Using Device Tree in place at 18000000, end 1800c339 Starting kernel ...

Dear Igor, I am sorry to disturbe again, now I am able to compile and create image (next-console), but the kernel still wont start on udoo-d and even not on udoo-quad Marcus

Deag Igor, thanks a lot. I will test today and give response.

Dear Igor, Thank you very mutch for tis great job! I did some tests based on your image with udoo-quad, works perfect! But I do have some trouble on udoo-dual, kernel stops without any console output (just loading kernel...) so I decided to compile my own, but I get [ o.k. ] Compiling uboot [ o.k. ] Compiler version [ arm-linux-gnueabihf-gcc 5.4.0 ] make: *** Keine Regel, um „udoo_qdl_config“ zu erstellen. Schluss. What do I have to change? Best regards Marcus