Flops

Anyway, as it turns out I didn't have "local access" enabled in the access point settings. LOL

When scanning the network via arp-scan it still writes (Unknown: locally administered).

Is there anything else I need to check?

And yes, that log I sent you is without the cable connected.

1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000 link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00 inet 127.0.0.1/8 scope host lo valid_lft forever preferred_lft forever inet6 ::1/128 scope host noprefixroute valid_lft forever preferred_lft forever 2: end1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000 link/ether 2a:77:33:98:ba:5a brd ff:ff:ff:ff:ff:ff inet 192.168.0.108/24 brd 192.168.0.255 scope global dynamic noprefixroute end1 valid_lft 7145sec preferred_lft 7145sec inet6 fe80::8a87:d850:159c:a59e/64 scope link noprefixroute valid_lft forever preferred_lft forever This is what the ip a gave me when I plugged in the cable.

When I connected to cable and uart it was able to update and download packages. I will try to copy the log again today. And I'll also check ifconfig

Here are the notes after the command log

Could you tell me how to conveniently transfer logs to a text file, because the terminal floats when scrolling?

I tried rebooting the router. Nothing changed in the end. The router does not respond to ping, but the board works properly via uart. Please help

It can work via uart, sshd works and yet it does not respond to a ping or ssh connection. At the same time it can connect to the internet and download packets by itself.

The system boots from the sd card and correctly. sshd is also active. Strange...

No, it was just me being stupid and mixing up the wires.

Saw this in the logs: INFOx4000001 != 0xfead0003 ERROR: INFO: BL31: Initializing Excervices WARNING: No OPTEE providon. SMC`s destined for OPTEE wil (eMMC) Maybe it means something?

I bought a uart and connected it as indicated in the video. The text is already readable, but sometimes it underwrites and moves away. What should I do next? Modified: it does not output correctly what I enter. Is there any way to improve it?

I bought it. I'll wait a month

Sorry, not paying attention

ok. I forgot to look. All right, I'll buy a proper adapter. Can you recommend an adapter or tell me where to look?

I use a CP2102 with UART Baud Rates: 300 bps -1 Mbps

I bought a uart and connected it according to the instructions in the video. I used screen and set the speed to 1500000 but the terminal shows only garbage. Maybe I should set a different speed?

In addition I want to say that when I tried to run armbian with usb ethernet started to light up and orange light. I am still waiting for the adapter to be delivered

Thanks for the answer. I'll give it a try. I do not have such an adapter, but I will buy it

Suddenly after updating via armbian-config I lost ssh access and found the port closed. I rewrote the latest armbian version, stuck the sd card in, connected to ethernet cable via router and started up. The red and green lights were on as they should be and the internet cable was flashing green. Waited 3 minutes and checked the ports with nmap. And the port is closed again. Not responding to ping at all. I am still new to this topic. Please help and sorry if the translator translates crookedly.