-
Posts
5 -
Joined
-
Last visited
Content Type
Forums
Store
Crowdfunding
Applications
Events
Raffles
Community Map
Posts posted by Steve Medley
-
-
OK. So i downloaded the source and built a test image from scratch. Booted it up and got the following log. The image did not boot successfully. I ended up pulling the plug on it after it stalled for a few minutes with the fan at 100%. Hope it helps.
-
Thanks. I quickly realised that was the problem when i typed help at the prompt and found the ext4load command missing.
Going to download the sources next so i can build my own test images and get a bit more familiar with the build process. I have built my own Armbian images in the past for CB2, but that was before it was even called Armbian and only supported CB2 and cubietruck. A lot has changed since then
-
OK. I finally got to boot up the image. Got the following:
U-Boot 2012.07 (Oct 20 2016 - 10:51:36) for Exynos5422 CPU: Exynos5422 Rev0.1 [Samsung SOC on SMP Platform Base on ARM CortexA7] APLL = 800MHz, KPLL = 800MHz MPLL = 532MHz, BPLL = 825MHz Board: HardKernel ODROID DRAM: 2 GiB WARNING: Caches not enabled TrustZone Enabled BSP BL1 version: / VDD_KFC: 0x44 LDO19: 0xf2 Checking Boot Mode ... SDMMC MMC: S5P_MSHC2: 0, S5P_MSHC0: 1 MMC Device 0: 7.4 GiB MMC Device 1: 29.1 GiB MMC Device 2: MMC Device 2 not found there are pending interrupts 0x00000001 *** Warning - bad CRC, using default environment In: serial Out: serial Err: serial Net: No ethernet found. Press quickly 'Enter' twice to stop autoboot: 0 ** Unable to use mmc 0:1 for fatload ** Unknown command 'ext4load' - try 'help' Unknown command 'ext4load' - try 'help' >>> Load Boot Script from mmc 0:1 <<< ** Unable to use mmc 0:1 for fatload ** >>> Load Boot Script from mmc 0:2 <<< ** Partition 2 not valid on device 0 ** ** Unable to use mmc 0:2 for fatload ** >>> Run Default Bootcmd <<< reading kernel..device 0 Start 1263, Count 16384 MMC read: dev # 0, block # 1263, count 16384 ... 16384 blocks read: OK completed reading RFS..device 0 Start 17647, Count 2048 MMC read: dev # 0, block # 17647, count 2048 ... 2048 blocks read: OK completed Bad Linux ARM zImage magic! Exynos5422 #
Going to look into it a bit further...
-
No worries. I have an XU4 currently running android on eMMC. i can throw xenial on an SD card and boot it up. i'll have a reply in about 2 hours
More proper testing - better Armbian experience
in Advanced users - Development
Posted
env print output: