cloudedmund

tried running sysbench. seems like the performance is close to RPi 2 even though the clock speed is similar to RPi3 monitoring the temperature and cpu load at the same time running sysbench seems like CPU max at 912MHz instead of 1200MHz without a heat sink, temperature reaching 55°C Doesn't seems like performance increase much after changing cpufreq to 1200MHz seems unstable. its due to throttling? still trying to figure out whether there's a way for nm to connect to hidden ssid automatically

i tried with another wifi. it seems working. i think the issue is that nm won't auto connect to wifi which have hidden ssid ps i don't think u can add/activate connection without sudo i can't even get ifconfig/iwconfig to run without sudo

nm seems won't autoconnect. i used nmcli c show home to check, connection.autoconnect : yes seems like autoconnect is yes, but it doesn't connect after reboot. still trying to figure this out

in win10 after doing the instruction from fel-mass-storage-master the emmc might be detected in other category i have to choose update driver and change it to mass storage device and i have to enable unsafe mode in etcher to be able to burn to the emmc to be safe, open disk manager in administrative tool to confirm which disk you're writing to. finally i got my neo pi air emmc flashed and running

Hi, I'm using win10 and trying to get my nanopi air to run without soldering. i use etcher for writing image to SD card. i followed the instruction from https://github.com/zador-blood-stained/fel-mass-storage i successfully run the start script, and i can see in Zadig that the device appear as "Allwinner device MMC 2 (eMMC)" (when i plugin the fel-sdboot) or "Allwinner device MMC 0 (SD)" (when i didn't plugin the SD card) but there's no drive shows up in window for either case, and no drive to be select in Etcher for both cases. any pointer on what i should do ? by the way, just a sharing, some USB cables just doesn't work, I fail to get the device to show up even in Zadig using an older cable. I changed the cable out of frustration after whole day failed attempt and suddenly it worked !