First time poster, hopefully I'll get along with all of you!
I am currently trying to connect a DS18(b)20 cable to my Banana Pi M2+, which is running Jessie Desktop. I connected the 3,3 V to Pin 1, GND to Pin 6 and Data to Pin 7, as well as the recommended 4,7k Ohm resistor between them.
Since, as I should have mentioned, I am an absolute beginner (literally just got into this a few days ago), I used a German tutorial for this, which told me to enter the following into my command module:
After which my /sys/bus folder shows a "w1" folder, which it does. However, the cable itself cannot be found. After some tinkering, I found that w1-therm does not seem to be found.
Is there any way to remedy this situation? Even just a hint would be greatly appreciated, as this is my first project with Armbian and I wish to go through with it instead of changing OSes.
Cheers